Tools and Accessories

Bushing sets for use on standard pen mandrels:

Luxury slimline pen or pencil bushings £4.50

All other bushings £6

• Slimline Pen or Pencil Kits
• Fountain Pen or Rollerball Pen Kits
• Sierra Pen Kit
• Pocket Fruit Knife Kit
• Carabiner Lighter Kit
• Golf Tee Pencil Kit
• Sketch Pencil Kit
• Engineering Pencil Kit
• Magnetic Pick up Pen Kit
• Diamond File and Sharpening Tool Kit
• Shaving Brush Kit
• Razor Kit 

 7mm brad point drill bit for slimline pen or pencils

8mm brad point drill bit for engineering and golf tee pencils

8.5mm brad point drill bit for diamond file

 10mm brad point drill bit for smaller diameter blank of Fountain & Rollerball pens

11.7mm reduced shank drill bit for larger diameter blank of Fountain & Rollerball pens 

12.3mm brad point drill bit for Fruit Knife 

13.2mm and 14.6mm reduced shank drill bits (2 bits) for Carabiner Lighter

27/64 drill bit for Magnetic Pickup and Sierra Pens 

15/32 reduced shank drill bit for Sketch Pencil

22mm Forstner drill bit for Shaving Brush

 Simplify inserting your glued pen tubes into your blanks. 

This tapered, chrome plated, glue resistant tool works with tubes from 7mm to 14.68mm dia. 

It keeps your fingers clean and safe from residual glue! Easy to clean.  Note that whilst this is glue resistant (non porous), glue may build up on the shaft, I sand this off when it is dry. The chrome will come off leaving aluminium, which is really easy to sand excess glue off. 

Colourful, double-sided sanding pads. These washable pads polish to a high sheen on wood and work equally well when used wet on acrylics. Each pack includes nine pieces of different colour coordinated weights. Pad size: 10.5cm X 8cm

 Abrasive Sanding Roll pack of 5 grits -  150, 240, 320, 400, 600 grits

 Perfect for Pen Turning.

Aluminium Oxide Sandpaper Roll

Each roll is 1" wide and 20 feet in length. J weight

 This pen blank centre finder is made of high-quality aluminium alloy material. It is anodized, durable, corrosion-resistant and wear-resistant. It is easy to use, suitable for round or square faced blanks using a right angle to draw the centre line and a round face to find the centre point.
Available in:

Black (small) 59*45*45mm

Blue (larger) 74*45*45mm 

This tool is great for leaving a dent in the centre of pieces of work for locating centres or bits. Spring loaded and very simple to use. Overall length approximately 125mm

 Stainless Steel Bottle Stopper Kit - including stopper, bit, mandrel and threaded tap.

 Includes (per kit):

1 x Stainless Steel (food safe) Stopper - Food level 304 stainless steel bottle stopper, 1 x 11/32 drill bit, 1 x 3/8 inch x16 Threaded Tap - Threaded Tap cuts a thread that allows you to easily thread a blank on the mandrel and provides a better bond when gluing the turned blank to bottle stoppers, 1 x Bottle Stopper Mandrel - Thread size: 3/8-16 (British Standard)

 1MT Revolving Tailstock. Ideally suited as a replacement part for the AT150PPL pen lathe. Fit the bar of the mandrel in to tailstock, which supports the work, but eliminates compression of the mandrel shaft.